Dometic RM 2553 Installation And Operating Instructions Manual page 4

INSTALLATION
GENERAL INSTRUCTION
This appliance is designed for storage off foods and
storage of frozen foods and making ice.
This appliance must be installed by an authorised
person and conform to all relevant local authorities.
The appliance shall be installed in accordance with
the manufacturer's installation instructions, local
gas fitting regulations, municipal building codes,
electrical wiring regulations, the AS 5601/AG 601 Gas
Installations, and any other relevant statutory regu-
lations.
The refrigerator must be installed on a solid floor and
must be level. With the vehicle carefully levelled, the re-
frigerator should level both ways in the freezer compart-
ment. (More about levelling is to be found under the head-
ing "Operating instructions").
Free air circulation over the fins of the cooling unit is
essential.
In case detailed instructions on the installation and con-
nection to the gas supply are required, contact your dealer
or distributor.
FIG. 3
Side view
D
H
Refrigerator
Model
Height
A
RM 2453 mm 948
RM 2553 mm 1104
This methods of installation and these clearances will give you adequate space for service and proper installation.
NOTE: Wood Strip
MUST be in place
Overall
Dimensions
Width Depth Height
B C H
632 627 928
632 627 1083
DATA PLATE
Check the data plate, inside the refrigerator, to ensure
that you have received the right model.
The right gas pressure is ........... 2,7 kPa.
The right voltage is ........... 230 - 240 volt.
The data plate contains e.g. the following details:
Model designation ....................................
Product number
Serial number
Since these details will be needed if you have to contact
service personnel, it is a good idea to make a note of
them here.
A W
Recess
Dimensions
Width Depth
W D
602 610
602 610
....................................
....................................
View from above
D
C
B
3