Dometic RM 2553 Installation And Operating Instructions Manual page 12

CHANGING DOOR HINGES FROM ONE
SIDE TO THE OTHER
The refrigerator is equipped with a reversible door.
A special door reversing kit must be used to reverse the
door.
For further information, please contact your dealer or
Dometic.
INSTRUCTIONS FOR MOUNTING THE
DOOR PANEL
The refrigerator is normally delivered with door panel.
Before starting the mounting work, check that the panel
dimensions are in compliance with those given in the
table and the instructions are read thoroughly.
When mounting the panel, proceed as follows:
See figure below.
A. Open the door 90 degrees.
Remove the door decoration strip (2) by removing
its three screws (1).
B. Insert the vertical edges into the grooves of the
door frame (3).
C. Push the panel downward so that the lower hori-
zontal edge of the panel (4) is fitted into the bottom
groove (5).
D. Put the decoration strip across the door so that the
gap is covered.
Secure the decoration strip with the three screws
removed in Step A (1).
1
1
1
1
2
1
1
PANEL DIMENSIONS
MAX. THICKNESS (4 mm)
REFR. MODEL HEIGHT
TYPE MAX.
RM 2453 mm 827
RM 2553 mm 983
Contact an authorized service center for
parts and repairs as needed.
3
4
5
WIDTH
MIN. MAX. MIN.
825 527 524
981 527 524
3
11