Setup Instructions - Band-it Ultra-Lok UL9010 Operating Instructions Manual

Setup
Instructions
Warning:
Always wear safety glasses when operating this tool. Keep both hands away from clamp being tensioned. Use
common sense, squeezing force of ¾" clamp can reach as high as 2 tons. Never attempt to clamp objects which
can shatter, or otherwise cause bodily harm.
Note: Read safety instructions and operator's manual of the METABO electric drill. Check to make sure drill is properly
set up for use with BAND-IT Ultra-Lok
Drill spindle has adapter clutch (BAND-IT # M03990) installed in place of standard drill chuck.
Gear selector must be on slow (setting 1), and set as shown on page 4.
Impact drive must be disengaged and set to (drill symbol).
1. Plug drill into standard 115V AC, 60 Hz outlet. If using and extension cord, a 14 gauge cord is suggested for
lengths up to 50 feet, 12 gauge cord required if running longer than 50 feet, 10 gauge cord if running over 100 feet.
2. To mount drill onto BAND-IT Ultra-Lok tool: First use the two #10-32 x 3/8" screws supplied with tool to tighten tool
adapter body to the tool. With adapter clamp on tool adapter body, insert drill into back of tool through the adapter
clamp. Turn drill manually to desired position in relation to tool. Press the drill firmly into tool. Actuate drill if
necessary to engage drill safety clutch (M03990) to tension screw. Tighten clamp screw while keeping the drill
firmly pressed against the tool. To remove drill from tool: loosen the clamp screw and pull drill away from the tool.
NOTE: When tightening the adapter clamp screw, safety clutch (M03990) must be engaged with tension screw
inside of BAND-IT tool.
3. This tool was designed for, and can only be used with BAND-IT Ultra-Lok
other type of clamp, it may damage tool. Note: An optional adapter can be purchased to apply ½" Ultra-Lok clamp,
see pages 5, 6, and 8 of this manual.
Use only with BAND-IT ¾ " Ultra-Lok Free-End and Preformed Clamps
Tension Block Position
Viewing Slot
(also lubrication syringe access)
Tool Head
Band Slot
Tool Body
Adapter
M07687
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
Ph: 1-800-525-0758
Fax: 1-800-624-3925
®
tool as follows:
Adapter Clamp
M08288
Adapter
Clamp
Tension
Screw
www.BAND-IT-IDEX.com
Page 3 of 14
UL9010
Ultra-Lok
®
clamps. Do not attempt to use on any
Gear Selector
(always set to 1)
Drill
M23587
Forward
Reverse
Selector
Switch
Document # P44987 Rev. N
© Copyright
BAND-IT-IDEX, Inc. 2011
All rights reserved
®
Tool