Advertisement
Operating
Instructions
1
LOAD CLAMP
Push tension handle all the way forward.
BAND-IT Center Punch clamp tail and push all the
way into tool.
Tool Tip: To apply 3/8" wide clamps, use S03289
adapter kit.
See attached instructions for 3/8"
adapter.
3
LOCK CLAMP
Holding tension handle down, lock clamp by hitting
punch at least twice with 2 lb. Mallet.
Note: Only use genuine BAND-IT Center Punch
clamps. Disregarding this may result in substandard
clamps or tool failure. BAND-IT CP clamps are made
out of Type 201 Stainless Steel or Galvanized Carbon
Steel material with a stainless steel buckle for added
strength.
BAND-IT IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925
FORWARD POSITION
OR "OPEN"
Insert
www.BAND-IT-IDEX.com
2
Tighten the clamp with short downward strokes. Tension
handle should be in down position at completion of
tightening clamp.
Note: Do not lift tension handle too high as it may open up
buckle pusher, resulting in improper clamp application.
If clamp tension needs to be released before locking, move
handle forward and move slide back against spring. This
raises pulling dog and releases clamp tension.
4
REMOVE CLAMP TAIL
Hold work-piece and pivot the tool back and forth to break
off clamp tail. Remove tail from tool by operating tension
handle. When tail has moved through holding dog, raise
tension handle and pull tail free.
Page 2 of 5
T30069
CP Hand Tool
SLIDE
TIGHTEN CLAMP
Document # P15087 rev. J
BAND-IT IDEX, Inc. 2013
All rights reserved
© Copyright
Advertisement
