Phase 5: Table Assembly - Central Machinery 67595 Set Up And Operating Instructions Manual

phaSe 5: table assembly

c
required hardware
letter description
A M8 x 80 Table Stop Bolt
C M8 x 30 Bolt
J M8 Lock Washer
K M8 Nut
Figure For StepS 5-1 to 5-3
attach through
theSe holeS
With BoltS (c)
132B
1. Set the Table Bracket (132B) onto the
saw body as shown above. Note that
the Table Stop bolt hole is on the side
with the Pulleys. The saw body has
alignment pins pre-installed to align the
Table Bracket properly.
2. Secure the Table Bracket to the Saw
Body using Bolts (C) and Lock Wash-
ers (J) through the holes noted above.
Tighten securely in place.
3. Thread the Nut (K) onto the Table Stop
Bolt (A). Install the Table Stop Bolt into
the hole noted in the figure above.
SKU 67595
a
j
qty
(for this phase)
taBle Stop
Bolt (a) hole
For technical questions, please call 1-800-444-3353.
Figure For Step 5-4
k
1
2
2
1
4. Attach the Lower Support Bracket (112B)
to the saw body near the Table Bracket
(132B). Secure in place with two Bolts
(119B) and Washers (120B) as shown
above. The hardware for this step is
packaged separately from the hardware
bag.
Figure For Step 5-5
127B
128B
5. Locate the Table Bracket (132B). Note
that there are two Bolts (128B) extend-
ing out from the bottom of the Trunnions
(127B). Insert those two Bolts through
the holes in the Table Bracket (132B) as
shown above. Secure the Bolts in place
using Knobs (131B).
132B
taBle (36B)
aSSeMBlY
132B
Page 15
112B
127B
128B