Installation & Configuration; Installation Steps; Hardware Configuration; Power - Mackenzie MacFi User Manual

2 INSTALLATION & CONFIGURATION
This section provides complete instructions for mounting the MacFi, 8 Message Digital Audio
Record / Play System on a wall or table. It also illustrates all interface requirements to
auxiliary equipment, including inputs and outputs. Configuration switch settings are provided.
2.1

Installation Steps

These are the general steps for installation.
1. Find a space on the wall or table. For table top applications, install included
rubber feet. Allow approximately 6 inches in front of, and 6 inches above the
unit for user access to the controls and wiring.
2. Mount the unit to the selected place with its wiring at least 18" away from
power supply or other equipment that generates electrical noise.
3. If you are using the optional power supply, make sure there is a standard
electrical outlet available.
4. Connect audio inputs and outputs.
5. Connect control inputs and outputs.
6. Set DIP switches to the desired operation.
7. Connect and apply power.
8. Test unit operation.
2.2

Hardware Configuration

2.2.1

Power

1 2
Two terminal pluggable connector.
1 12 VDC at 1 amp
2 Ground
Power LED
Green LED which indicates
that power is supplied to the
unit and operating correctly
Off No power supplied to unit
On Power on, system OK
Blink Power on, system malfunction,
see memory test procedure
3