Installation & Configuration; Installation Steps; Hardware Configuration; Power - Mackenzie MacFi-se User Manual

2. INSTALLATION & CONFIGURATION
This section provides complete instructions for mounting the
MacFi-se, MP3 Digital Audio Record / Play System on a wall or
table. It also illustrates all interface requirements to auxiliary
equipment, including inputs and outputs. Configuration switch
settings are provided.

2.1 Installation Steps

These are the general steps for installation.
1. Find a space on the wall or table. For table top applications,
install included rubber feet. Allow approximately 6 inches in front
of both sides of the unit for user access to the controls and
wiring.
2. Mount the unit to the selected place with its wiring at least 18"
away from power supply or other equipment that generates
electrical noise.
3. Set DIP switches to the desired operation.
4. Connect audio inputs and outputs.
5. Connect control inputs and outputs.
6. If using the optional power supply, make sure there is a
standard, non-switched electrical outlet available.
7. Connect and apply power.
8. Test unit operation.

2.2 Hardware Configuration

2.2.1. Power Connector
Two terminal pluggable connector.
1 12 VDC at 1 amp
2 Ground
Power LED
Green LED which indicates
that power is supplied to the
unit and operating correctly
8
Off No power supplied to unit
On Power on, system OK
3.3 Playing-Local
Local playback is achieved through the LED's and buttons located
on the front side of the MacFi-se unit. Please reference the
Manual Button & LED Configuration section of this manual for
additional information on functions.
Step 1 – Make all desired power, audio out, configuration switch
and I/O connections to the unit and power up. Unit will initiate
self test and default to idle mode.
Step 2 – Use Select button to determine message location to play.
Select button will only increment between valid message
locations, showing them on the Message Number Display.
System will scan/blink through all segments on the Message
Number Display and exit if no valid messages exist when Select
button is depressed.
Step 3 – Depress Start/Stop button to begin playback. Message
LED will remain solid during playback.
Step 4 – Depress Start/Stop button to end playback and return to
idle.
Playback message selection will time out after 1 minute of
inactivity. Default message is the first location with a valid
recording.
3.4 Playing-Remote Control
Remote Control playback is achieved through the I/O connections
located on the rear side of the MacFi-se unit. This process is only
applicable to the first eight messages on the system. Please
reference the Hardware Configuration section of this manual for
additional information on available connections. Playback of
message will include selected repeat and delay parameters.
21