Recording - Remote Control; Playing-Local - Mackenzie MacFi User Manual

Step 4 – Listen to record source through monitor and/or reference Overdrive
LED to verify level and queue material.
Step 5 – Depress Start/Stop button to begin recording and start audio source.
Message and Record LED's will remain solid during recording.
Step 6 – Depress Start/Stop button to end recording and exit Record Setup
Record setup will time out after 1 minute of inactivity.
3.2

Recording - Remote Control

Remote Control recording is achieved through the I/O connections located on the
endplate of the MacFi unit. Please reference the Hardware Configuration section of
this manual for additional information on available connections.
Step 1 – Make all desired power, audio in, audio out, configuration switch and
I/O connections to the unit and power up. Unit will initiate self test and
default to idle mode
Step 2 – Provide a maintained input signal to the Record Input(Connector 2
terminal 1), this will blink the Record LED.
Step 3 – Provide a maintained input signal at the message activation input
desired(Connector 1, terminals 2-9). Both the Record and
corresponding Message LED's will remain solid during recording
Step 4 – Start audio source.
Step 5 – Release message activation input to stop recording.
Step 6 – Release recording input to exit record mode.
3.3

Playing-Local

Local playback is achieved through the LED's and buttons located on the top of the
MacFi unit. Please reference the Manual Button & LED Configuration section of this
manual for additional information on functions. Playback of messages will include
selected repeat and delay parameters.
Step 1 – Make all desired power, audio out, configuration switch and I/O
connections to the unit and power up. Unit will initiate self test and
default to idle mode.
Step 2 – Use Select button to determine message location to play. Select button
will only increment between valid message locations and the individual
message LED's will blink. System will scan/blink through all message
LED's and exit if no valid messages exist when Select button is
depressed.
Step 3 – Depress Start/Stop button to begin playback. Message LED will remain
solid during playback.
Step 4 – Depress Start/Stop button to end playback and return to idle.
Playback message selection will time out after 1 minute of inactivity.
12