Select Button; Message Led's; Operation; Recording - Local - Mackenzie MacFi User Manual

If a message is setup for recording, with both the record and the message LEDs
blinking, pressing this button will initiate the recording process. Pressing it again,
with the recording in process, will stop the recording.
Pressing this button with no LEDs blinking will have no effect.
2.3.6

Select Button

This button selects the message for recording or playing. Depressing this button
sequences through the individual message positions, represented by the message
LED's. The Select button may be used during record setup or to initiate playback
mode when the system is idle.
2.3.7

Message LED's

These green LED's indicate which message is selected. The function of the
message LED is determined by its activity in relation to the Record LED.
Msg LED Msg LED
Off Off
Blink Off
On Off
Scan All Off
Blink Blink
On Blink
On On
NOTE: In play mode, Select button circulates through only valid recorded message
locations.
3.1

Recording - Local

Local recording is achieved through the LED's and buttons located on the top of
the MacFi unit. Please reference the Manual Button & LED Configuration section of
this manual for additional information on functions.
Step 1 – Make all desired power, audio in, audio out, configuration switch and
I/O connections to the unit and power up. Unit will initiate self test and
default to idle mode.
Step 2 – Depress Record Setup button, Record LED will blink
Step 3 – Use Select button to determine message location to record to. Individual
message LED's will be solid when not occupied and blink when message
location is occupied.
System idle
Select message mode
Message playing
No messages recorded
Select message to record,
location contains message
Select message to record,
location empty
Recording in progress

3 OPERATION

11
Cause
N/A
Select button
Start/Stop button
Select button
Record Setup button, Select
button
Record Setup button, Select
button
Record Setup button, Select
button, Start/Stop button