TRENDnet TVP-224HR System Integrator's User Manual page 47

Appendix B - Connecting through Console
The console port uses a DB-9 RS-232 connector. The supplied straight through RS-
232 cable connects the console port of the TVP-224HR to a console PC or terminal.
Task
Connect RS-323 Cable to TVP-224HR RS-232
console port a your computer that you will use as
a configuring terminal
Open HyperTerminal and enter the following Input
Parameters when prompted:
When the empty HyperTerminal Screen appears
type "123"
In the event that you forget your administration
password, you can gain console access to the
TVP-224HR using the super password. The super
password is the last six digits of your MAC
address located on the bottom of your TVP-224HR
(00-50-2d-xx-xx-xx). At the Console prompt enter
the super password without hyphens. The
password is all lower case. After gaining access,
at the console prompt type in
net set manager password
<new_password> <new_password>
net store
net reset
If entry of new password is successful, the console
will list "OK". You will now be able to gain Web
Access from a PC in the same local segment
using the TVP-224HR LAN IP Address. If Web
and / or Telnet Access are enabled, you will also
be able to remote access the TVP-224HR by
entering http:// followed by the TVP-224HR WAN
IP or domain name.
At the prompt
Console>
Enter ping 168.95.1.1
The following dialogue indicates that Internet
Access is successful.
Prompt
Baud rate
Number of data
bit
Parity check
Number of stop
bit
Flow control
Console>
Type
19,200
8
None
1
None
123
ping
168.95.1.1