TRENDnet TVP-224HR System Integrator's User Manual page 14

password is the last six digits of your MAC
address located on the bottom of your TVP-224HR
(00-50-2d-xx-xx-xx). At the Console prompt enter
the super password without hyphens. The
password is all lower case. After gaining access,
at the console prompt type in
net set manager password
<new_password> <new_password>
net store
net reset
If entry of new password is successful, the console
will list "OK". You will now be able to gain Web
Access from a PC in the same local segment
using the TVP-224HR LAN IP Address. If Web
and / or Telnet Access are enabled, you will also
be able to remote access the TVP-224HR by
entering http:// followed by the TVP-224HR WAN
IP or domain name.
At the prompt
Console>
Enter ping 168.95.1.1
The following dialogue indicates that Internet
Access is successful.
ping 168.95.1.1
1 out of 1 pings succeeded.
Console>
If the ping times out, you do not have Internet
Access. Please refer to the trouble shooting
section of the User Manual or consult your ISP to
make sure your Internet Access Data is correct
and accurately entered into the TVP-224HR.
The following commands enable / disable web and
telnet access respectively.
Net set http <on/off>
Net set telnet <on/off>
To reset to Factory Default settings, please
perform the following commands to:
Erase all 'port', 'codec' & 'h323' configuration
config erase
Then access dial plan edit mode by entering
atpm req
Purge the dial plan from the database
atpm purge all
Store the changes
atpm store
Reset the network configuration to default
net set fac_default
Key in "yes" to re-boot.
Console>
Console>
ping
168.95.1.1
on / off