Factory Mode Introduction; After Repair, To Ensure The Quality You Should Do The Following Test And Adjustment - BenQ G700 Service Manual

BenQ G700
SYSTEM

4.2.3.3. Factory Mode Introduction

When signal is input, press "power key" to turn off the monitor. Press "ENTER"+"MENU" +"Power" together
to turn on the monitor. After power on, press "MENU" to call out Main Menu, then press "-"for select the "F" item,
then press "power/menu", you can go into Factory mode.
EXIT: Escape from Factory menu.
PANEL: Display panel information.
AUTO COLOR: Automatically calibrate chip ADC parameter by using chip internal DAC.
GAIN: ADC gain value
OFFSET: ADC offset value
9300K: Set color temperature 9300K
6500K: Set color temperature 6500K
USER: Set user preferred color temperature
LANGUAGE: Country language
Reset BL Hr: the time of backlight
Reset Total Hr: the total time when connect power
Return: exit the factory menu

4.2.3.4 After repair, to ensure the quality you should do the following test and adjustment

Item
Test OSD 1.Signal is set as1280×1024@60Hzunder General-1
function 2.Checking whether each single function key and compound function key
can be worked.
Input (D-sub/DVI)
OSD Settings Language
H. Position
V. Position
OSD Settings
Display Time
DDC/CI
OSD Lock
Information
(ON/OFF)
Reset All (YES/NO)
Content
-EU version: 14 languages
(English/Français/Deutsch/Italiano/Espanol/Poli
sh/Czech/Hungarian/Serbo-croatian/Romanian/
Netherlands/Russian/Swedish/Protuguese)
-Asian version: 8 languages
(English/Francais/Deutsch/Italiano/Espanol/日
(5, 10, 15, 20, 25, 30)
-
23
Service Manual
本語/繁體
中文/简体中文)
(0~100)
(0~100)
(YES/NO)
-
-
-
Equipment
Chroma
Signal Generator
English
50
50
15
No
Yes