Alignment Procedure (For Function Adjustment); Preparation; Timing Adjustment; Function Key Definitions - BenQ G700 Service Manual

BenQ G700
corresponding firmware version, and load to MCU.
3. After finish, please plug out power cable and re-start monitor again.

4.2 Alignment procedure (for function adjustment)

4.2.1 Preparation:

1. Setup input timing VESA to 1280*1024@60Hz,32-Grays pattern.
2. Setup units and keep it warm up for at least 30 minutes.

4.2.2 Timing adjustment

1. Enter to factory mode setting area (by pressing "ENTER"+ "MENU" + "POWER" at the same time during
power off).
2. Check the settings to following values:
Contrast =50;
Brightness=100;
Color enhancement=general;
3. Then turn off the monitor power.

4.2.3 Function key Definitions

4.2.3.1 Control buttons on the Back bezel

"UP"
•
•
•
•
Activate the Brightness/Contrast Control menu
View the next function in the OSD Main menu
Increase the value of the specific function which has been selected
"MENU"
Activate the Control Button Description menu
Activate the OSD Main menu
View the next function in the OSD Main menu
"DOWN"
Activate the Theme Mode menu
View the previous function in the OSD Main menu
Decrease the value of the specific function which has been selected
"AUTO"
Activate the Auto Adjustment function
Go back to the OSD Main menu from the sub-menus
Exit from the OSD Main menu
"ENTER"
Perform function of menu icon that is highlight or enter next level menu
Enter the OSD item
21
Service Manual