Alcatel-Lucent OmniSwitch 6250 Management Manual page 145

Managing CMM Directory Content
To save the running configuration to the working directory, enter the
write memory command at the prompt, as shown:
-> copy running-config working
or
-> write memory
The preceeding commands perform the same function. When these commands are issued the running
configuration with all modifications made is saved to a file called boot.cfg in the working directory.
Note. This command does not function if the switch is running from the certified directory. See
the Switch Running From?" on page 5-4
The copy running-config working
OmniSwitch 6250/6450 CLI Reference Guide.
Note. The saved boot.cfg file is overwritten if the
copy running-config working
CMMs.
Note. It is important to certify the working directory and synchronize the stack as soon as the validity of
the working directory software is established. Stacks booted from the working directory or unsynchro-
nized stacks are at risk of mismanaging data traffic due to incompatibilities in different versions of switch
software. Certifying the working directory is described in
fied Directory" on page
and Secondary CMMs" on page
OmniSwitch 6250/6450 Switch Management Guide
for an explanation.
and write memory
or write memory
5-21, while synchronizing the switch is described in
5-27.
May 2012
Managing the Directory Structure (Non-Redundant)
copy running-config working
commands are described in detail in the
takeover command is executed after the
commands in an OmniSwitch set up with redundant
"Copying the Working Directory to the Certi-
or
"Where is
"Synchronizing the Primary
page 5-17