Wiring - Phase Linear UV8035 Owner's Manual

Multimedia receiver
Table of Contents

Advertisement

WIRING

WARNING! Never combine
(bridge) outputs for use with 1
speaker.
WARNING! Never ground
negative speaker leads to
chassis ground.
CAUTION: Failure to wire exactly
as shown may cause electrical
damage to the radio.
Subwoofer Out
(Blue)
Fuse (15A)
Parking
Connect to switched side
of parking brake circuit.
Pink
Ground
Connect to ground terminal
or clean, unpainted part of chassis.
Black
Memory/Battery
Connect to battery or 12 volt power
source that is always live. The radio will
not work if this wire is not connected.
Yellow
FRONT SP
White/Black
White
Gray/Black
Gray
Stripe
Stripe
Left Speaker
Right Speaker
(Front)
(Front)
Rear Line out
R (Red)
Gray
L (White)
Front r Line out
R (Red)
Black
L (White)
Power Antenna
Connect to power antenna. If not used, tape bare end of wire.
Blue
Power Amplifier
Connect to power amplifier. If not used, tape bare end of wire.
Blue/White
Accessory/Ignition
Connect to existing radio wire or radio fuse.
Red
REAR SP
Green/Black
Green
Purple/Black
Purple
Stripe
Stripe
Left Speaker
Right Speaker
(Rear)
(Rear)
6
UV8035
Aux-In (Black)
R (Red)
Video In
L (White)
(Yellow)
Video Out 1
(Yellow)
Video Out 2
(Yellow)
IMPORTANT!
The pink parking wire MUST
be connected to the switched
side of the parking break
circuit (the part that becomes
grounded when the brake is
applied).

Advertisement

Table of Contents
loading

Table of Contents