FujiFilm FinePix30i Service Manual page 30

4.Adjustment
(3)Hardware
From the [Customize] dialog box, select [Hardware]. Se-
lect [Debug Mode]. (Fig. 10)
Debug Mode
(4)Etc.
From the [Customize] dialog box, select [Etc.]. This is
used for other settings. (Fig. 11)
of auto-measure
Change mode
Use Japanese font
In [Etc.], setting [Don't show OK NG] to off will allow
[OK] to be displayed on the computer screen if the
adjustment is good and [NG] to be displayed if it is
bad. (Either setting can be used.)
Apply & OK
(5)
This saves the settings made in [Customize].
(Fig. 12)
*Always click [Apply] and [OK] after all
the settings have been completed.
This will save the settings.
Fig.12
(2)
30
Ignore Focus I/O
Fig.10
O
Do not check(=not used)
Do not check(=not used)
Fig.11
(1)
FinePix30i(U/E/EG) SERVICE MANUAL
Precautions when making
adjustments
O:After adjustments have been completed,
the DC power supply of the camera is
pulled out forcibly, and adjustment is fin-
ished.
O:If the power switch for the camera has been
set to off during adjustment mode (during
camera service mode), disconnect the DC
input terminal and then reconnect it be-
fore turning the power for the camera on
again.
O:If a [NG] appears during adjustment and
the program stops, restart the adjustment
software and redo the adjustment.