Controls And Features - MTD 510 Series Operator's Manual

Controls and Features

Cylinder
Tongue
NOTE: This Operator's Manual covers several models. Log splitter
features may vary by model. Not all features in this manual are
applicable to all log splitter models and the log splitter depicted
may differ from yours.
Engine Controls
See the Engine Operator's Manual for the location and function
of the controls on the engine.
Beam Locks
These two locks are used to secure the beam in the horizontal or
vertical position. The vertical beam lock is located next to the oil
filter. The horizontal beam lock is located on the beam support
latch bracket.
Control Handle
The control handle has three positions; Forward, Neutral and
Reverse. See the Operation Section for instructions.
Wedge
The wedge is used to split the wood.
10
Log Dislodger
Jack Stand
Control Handle
Wedge
Vertical
Beam
Lock
Tail Light
Figure 4-1
Tail Light (If equipped)
The tail light's are located on the back of the frame for
transportation and towing purposes.
WARNING!
check the local, state, and federal requirements
before towing on any public road.
Log Dislodger
The log dislodger is designed to remove any partially split wood
from the wedge. This may occur while splitting large diameter
wood or freshly cut wood.
Control Handle
The Control Handle is used to move the wedge up and down to
split wood.
Tongue
The tongue is used to attach to a towing vehicle for
transportation.
Horizontal
Beam Lock
Beam Assembly
Log
Cradle
Do not tow faster than 45mph and
4