Preset Stations - Jensen Phase Linear CD1213 Owner's Manual

NOTE: The Scan function does not work
correctly in "MANUAL" mode.

Preset Stations

Up to six stations on each band can be stored
as presets and can then be instantly recalled by
pressing the associated preset button on the
front panel (19-24) or remote control. To store a
station, turn the radio on and select the desired
band and station. Press and hold the desired
preset button (numbered one through six on the
face of the radio or remote control) for more
than two seconds. When stored, the preset
number will appear in the display. The station is
now stored and can be recalled at any time by
pressing the corresponding preset button.
Repeat for the remaining five presets on the
current band and for all presets on the other
three bands.
Preset Scan / Automatically
Store (PS/AS)
Automatically Store
Select six strong stations and store them for all
bands using the Automatic Store feature. To
enable this feature, press and hold the PS/AS
button (17) for more than two seconds. The
radio will automatically scan each band and
enter strong stations into the preset memory
positions. After entering the stations into
memory, the unit will automatically stop at each
station for five seconds so each can be heard.
When using the Automatically Store feature, the
new stations replace any stations already
stored in preset memory.
Preset Scan
Press the PS/AS button (17) to scan the six
preset stations in the AM band or all FM bands.
The unit will stop at each station for five
seconds before continuing to the next preset
station, and the preset number will flash on the
display during the preset scan. Press PS/AS
again to stop scanning and listen to the current
station.
Mono/Stereo Selector (MONO)
Press MONO (18) during FM radio operation to
select mono reception of the broadcast signal.
Under normal reception, the unit should be left
in the stereo mode, as indicated by the "ST"
designation that appears on the display panel
when tuned to an FM stereo signal. If the signal
is too noisy for comfortable listening, press
MONO to switch to mono reception. The "ST"
indication will disappear. Press MONO again to
return to stereo mode.
Local / Distance Selector
This feature is used to designate the strength of
the signals at which the radio will stop during
automatic tuning. Distant, or "Dx" is the default
setting, allowing the radio to stop at a broader
6
range of signals. To set the unit to select only
strong local stations during automatic tuning,
press the LO/DX button (25). The "LOC" icon
appears in the display when LOCAL reception
mode is selected.
CD1213