Table of Contents
Advertisement
Optelec
All possible configurations shall comply with the current version of the
•
standard for SYSTEMS IEC/EN 60601-1-1 directive.
When connecting additional equipment to the signal input part or signal output
•
part of the device, be aware a medical system is being configured. Therefore,
the person who configures and interconnects the system is responsible for the
whole system and needs to make sure it complies with the current version of
the requirements of the system standard IEC/EN 60601-1-1. In case there is
any doubt about the system compliance with the current version of the
requirements of the system standard IEC/EN 60601-1-1, consult the technical
service department or your local representative.
Explanation Of Graphical Symbols:
This symbol warns user that uninsulated voltage within the unit may have
sufficient magnitude to cause electric shock. Therefore, it is dangerous to
make any kind of contact with any part inside this unit.
This symbol alerts the user that important literature concerning the operation
and maintenance of this unit has been included. Therefore, it should be read
carefully in order to avoid any problems.
Stand-by
Direct Current
Safety Logo:
This device complies with the
93/42/EEC, EN60601-1,EN60601-2
of related European standards.
Disposing of your old product:
-If you see this symbol-
Information on Disposal for other Countries outside the
European Union.
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local
authorities or dealer and ask for the correct method of disposal.
Classification:
Power by Class I power adapter: TRC-05-2000M
No Applied Part.
•
English
Page 42
Advertisement
Table of Contents
