Advertisement
6. Training in WATT mode:
The preset watt value 120 is flashing on screen in WATT setting mode, select UP/DOWN/ENTER
to set target value from 10 to 350.
CLOCKWISE OR
COUNTER-CLOCKWISE
CLOCKWISE OR
COUNTER-CLOCKWISE
CLOCKWISE OR
COUNTER-CLOCKWISE
9. Traning in BODY FAT mode:
You may test and have the BODY FAT advice when the computer is in STOP mode. Please
follow the steps below:
Step I - Make sure the personal data has been entered and is correct.
Step II - Press BODY FAT button, and hold on handgrip to start body fat testing.
Step III - The symbol "--------------" will display while testing period in 8 seconds. After 8 seconds,
you will see the BODY FAT advice in percentage (*1) and BMI (*2) and the fat advice in
different symbol. It would be possible to display other indications if you have the following
situation:
1. "E-1" When you see this indication, it means you did not put your thumb properly on
the conductor. Please try again.
2. "E-4" When you see this indication, it means the BODY FAT advice has exceeded the
available area which is fixed in the program.
After BODY FAT testing, press BODY FAT button to have the computer revert back to the previous data
before testing. The BODY FAT advice figure and BMI will disappear. The computer may allow the other
people to test BODY FAT under STOP mode. The user may press RESET button for 4 seconds to select new
user identification and input new personal data. Then follow each step as above to have the new
testing.
CLOCKWISE OR
COUNTER-CLOCKWISE
CLOCKWISE OR
COUNTER-CLOCKWISE
CLOCKWISE OR
COUNTER-CLOCKWISE
CLOCKWISE OR
COUNTER-CLOCKWISE
Advertisement
