Advertisement
CONNECTING...
When selecting wire for connecting speakers,
speaker wire
is used
for normal length runs, and up to 12-gauge speaker wire
30 feet.
Before making a connection, ensure that your audio source is powered off as severe damage to
equipment and/or your ears could result.
The Speakers
I.
For proper connection, be sure to connect all of the speakers in your system in an identical
manner: Red or (+) amplifier/receiver terminal to Red (+) speaker terminal, Black (-)
amplifier/receiver terminal to Black (-) speaker terminal.
II.
A proper connection will ensure that each speaker driver cone on both channels move forward
and backward together ("in-phase"), rather than in opposition ("out-of-phase").
I .
II
Using the below wire-coding diagrams, ensure you are connecting the same wire of a given pair
to a like-coded terminal on both ends of the connection.
Bare Wire Connection
Push the top of the binding post
down to line up the two holes.
Insert wire through hole, and
release binding post. This
connection will accept up to
8-gauge wire.
Note: The PSB Imagine W1 and W3 perform best when complemented with a powered subwoofer.
PSB Speakers offers a number of suitable subwoofers to pair with your on-wall speakers. To find these
subwoofers, please visit www.psbspeakers.com
it is
highly recommend
Observe Proper Connection Polarity
5
ed that
a minimum of 16-gauge
is used
Banana Plug Connection
Remove binding post plugs and
insert the banana plug into the
top of the binding post.
for long runs over
Advertisement
