Mitsubishi GOT1000 Startup Manual page 6

GT Designer 2
(Version 2.73 or later)
To make sure the GT1020/GT1030 GOT is able to use
the latest functions and features, it is the responsibility
of the user to check and update the firmware (Standard
monitor OS) of the GOT.
Launch the latest copy of GT Designer2 and start a new project for the
corresponding GOT model (GT1020 or GT1030) with the "FREQROL500/700"
Inverter Type. Select "Yes" to set the Communication Setting and make sure
the Standard I/F-1 CH No. is set to 1 before selecting "OK". The "Screen
Property" window that pops up for making a new screen can be either
canceled or accepted for the following steps.
Go to the "Communication" menu and select "To/From GOT" to bring up the
"Communicate with GOT" window. Go to the "Communication configuration"
tab and select "RS232" and the corresponding "Port No." that connects the
PC to the GOT. With the GOT power ON, use the "Test" button to verify that
the PC and GOT can communicate properly then turn the GOT power OFF.
Installing OS and Communication Drivers
To access the OS installation mode of the GT1020/GT1030, switch the GOT
power from OFF to ON, while holding the bottom right corner of the touch
screen (in Horizontal layout), illustrated below:
6
Note: This document is for reference only. For detailed settings and safety information refer to the respective product manual.