How To Use The Indoor Unit - White-Westinghouse WAS12P5CHLWP Instruction Manual

To set the stopping time
1. Push the TIMER OFF button and the remote controller will show TIMER
OFF, the last set time for the stopping operation and the signal "h" will be
shown on the DIGITAL DISPLAY area. You are now ready to reset the time
of the STOP operation.
2. Push the TIMER OFF button again to set the time you want to stop the
operation.
3. After setting the TIMER OFF ,there will be a one-half second delay before
the remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" disappears and the set
temperature will re-appear on the digital display.
Exemples:
ON ON
OFF OFF
6h 6h
(Temp On) (Temp Off)
Optimal operation
To achieve optimal performance, please note the following:
1. Adjust the air flow direction correctly so that it is not directed on people.
2. Adjust the temperature to achieve the highest comfort level. Do not adjust
the unit to excessive temperature levels.
3. Close doors and windows on COLD or HEAT modes, or performance may
be reduced.
4. Use TIMER ON button on the remote controller to select a time you want
to start your air conditioner.
5. Do not put any object near air inlet or air outlet, as the efficiency of the air
conditioner may be reduced and the air conditioner may stop running.
6. Clean the air filter periodically, otherwise cooling or heating performance
may be reduced.
7. Do not operate unit with horizontal louvre in closed position.
How the air conditioner works
41
ON ON ONN
OFF OFF
12h 14h 20h
(Temp Off) (Temp On) (Temp On)

How to use the indoor unit

Adjusting air flow direction
Adjust the air flow direction properly
otherwise, it might cause discomfort or
cause uneven room temperatures.
Adjust the horizontal louver using the
remote controller. Adjust the vertical
louver manually.
Adjusting the vertical air flow
direction (up - down)
The air conditioner automatically
adjusts the vertical air flow direction in
accordance with the operating mode.
To set the horizontal air flow
OFF direction (left/ right)
Adjust the vertical louver manually
23h
using the lever on the left or right side
(Temp Off)
of the vertical louver arm (Depending
on model). Take care not to catch
fingers on the fan, horizontal louver or
to damage vertical louvers. When the
air conditioner is in operation and the
horizontal louver is in a specific
position, move the lever at left (or
right, depending on model) end of the
air outlet to the desired position.
To automatically swing the air flow
direction (up/down)
Perform this function while the air
conditioner is in operation.
Press the SWING button on the remote
controller.
To stop the function, press the SWING
button again.
Lever
How to use the indoor unit
42