White-Westinghouse WAS12P5CHLWP Instruction Manual page 21

DRY operation
The dry mode will automatically
select the drying operation based on
the difference between the set
temperature and the actual room
temperature.
The temperature is regulated while
dehumidifying by repeating turning
on and off of the cooling operation
or fan only. The fan speed is LOW.
1. Push the MODE button to select
DRY.
2. Push the TEMP button to set the
desired temperature from 21ºC to
28ºC.
3. Push the ON/OFF button, the
operation lamp lights and the air
conditioner start to operate in the
DRY mode. FAN SPEED is Low.
Push the ON/OFF button again to
stop this unit operation.
Air flow direction adjustment
Use SWING to adjust the airflow direction up and down.
1. When swing is pressed the horizontal louver moves up and down
automatically. Press again to stop operation.
Attention
If the louver oscillates or moves in a position that could affect the cooling or
heating of the air conditioner the direction of the oscillation/movement would
alter automatically.
How the air conditioner works
39
Attention
Due to the difference of the set
temperature of the unit and the actual
indoor temperature, the Air Conditioner
when in DRY mode will automatically
operate many times without running the
COLD and FAN mode.
Room
Temperature
Time
Set temperature
DRY FUNCTION
SLEEP mode
Press the sleep button to activate the
sleep mode. To deactivate, press the
button again.
Cold only mode:
• The indoor unit fan operates at a
low velocity.
• After and hour of operation, the
adjusted temperature will increase
1º C. After, the unit keeps operating
2ºC above the adjusted
temperature.
In heating mode (some models):
• The indoor unit fan operates at a
low velocity.
• After and hour of operation, the
adjusted temperature will decrease
1º C. After, the unit keeps operating
2º C below the adjusted
temperature.
TIMER Operation
TIMER button can set the auto-on time of the unit.
To set the starting time
1. Push the TIMER ON button, then the remote controller shows TIMER ON ,
the last set time for the starting operation and the signal "h" will be shown
on the DIGITAL DISPLAY area. You are now ready to reset the time to START
the operation.
2. Push the TIMER ON button again to set desired unit start time.
3. After setting the TIMER ON ,there will be a one-half second delay before
the remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the signal "h" disappears and the set
temperature will re-appear on the digital display.
How the air conditioner works
Attention
Sleep function is only availaible in
the Cold/Heat and AUTO mode.
1 °C
1 °C
1 hour 1 hour
SLEEP FUNCTION (Cooling mode)
1 °C
1 °C
1 hour 1 hour
7 hours
SLEEP FUNCTION (Heating mode)
40