Receiver Module C 7188; Operation Of C 7188 Bluetooth Receiver - Okayo Portable PA System User Manual

Okayo Portable PA System
Figure 11: Bluetooth® receiver module C 7188

Operation of C 7188 Bluetooth Receiver

1. Turn the knob clockwise to switch on the Bluetooth module. Set a mid-range volume level to begin.
2. You will hear a tone and the PWR indicator (LED) will light blue. The LINK indicator will also flash blue to indicate
that the module is ready to pair with another Bluetooth device.
3.When in pairing mode, activate a Bluetooth connection scan on your smartphone or tablet or similar device that will
serve as a source of audio. When the search is complete, select a device named "Portable PA" from the pairing list.
You device will attempt to connect with the Bluetooth module.
4. When the devices have successfully paired, the module will sound a prompt tone again. The LINK will light steady
blue.
5. You are now ready to stream audio via the Bluetooth connection from your smartphone or tablet. You can adjust
the audio volume on your device or using the volume knob on the Bluetooth receiver module.
6. The AF indicator will light when an audio signal is streamed from your playback device and received by the
Bluetooth module.
7. If a phone call is incoming during playback, the audio stream will be interrupted for the user to take the call. When
the call is finished, the Bluetooth module will be automatically relinked and audio files will recommence playback
from where they were interrupted.
8. When a user moves out of range for the Bluetooth connection, the audio stream will be severed until the user
returns to a location within range of the module. The range is about 10 metres. However, it depends on what kind of
operating system is installed on the smartphone or tablet. Sometimes it will be necessary to manually reconnect to
the Bluetooth following the steps above.
14
1. Power indicator
2. Bluetooth connectivity indicator
3. Audio frequency indicator
4. ON/OFF Volume switch