Table of Contents
Advertisement
Chapter 4 Electrical Connections
After the VXD-R70 Repeater has been mechanically installed, electrical connections must be
made. This involves making the following connections:
•
AC power cord, and
•
antenna coaxial cables
Figure 4-1 shows the position of the various connectors and connections on the rear panel of
the repeater.
Figure 4-1: Locations of Connectors on the Rear Panel of the Repeater
4.1
Power Supply Connections
4.1.1
AC Input Power Connection
NOTE: The AC source must be installed near the equipment and must be easily accessible.
Each repeater ships with a 2.438 m (8 feet) 3-conductor line cord that connects the repeater to a
110/120/220/240 VAC source. Figure 4-1 shows the location where the AC line cord connects to the
repeater. Insert the 3-prong plug into a 110/120/220/240 VAC grounded outlet.
If an alternate line cord is required, obtain a suitable line cord, with fittings approved by the safety
testing agency in the end-use country, from a certified electrical parts supplier.
Do NOT apply AC power to the repeater at this time. Make sure that the cir-
cuit breaker associated with the AC outlet is turned to OFF.
Chapter 4 Electrical Connections
Page 15
Advertisement
Table of Contents
