Jenn-Air CCG2423 Installation Manual page 9

TOCONVERT A PPLIANCE FORUSEWITH INSTALLATION OFNATURAL GAS
NATURAL G AS ORIFICE SPUDS
WARNING
I
4 BURNER MODEL
J
Electrical power and gas must be turned off p rior to
conversion.
If this appliance hasbeenconverted forusewithLPgas,eachofthe
following m odifications must be performed t oconvert t heunitbackto
natural gas.
A. Replace allorificespuds
Perform Steps 1 through 4 onpage 5.
For Step5:Locate t hecolored b rass natural gasorifice s puds t hat w ere
originally installed inthis appliance before itsconversion foruse with LP
gas.Observe thecolor o feach ofthespuds a nd notethe c orrect burner (_ (_
location foreach spud as shown infigures 14and15. _ (_ (_
Complete Steps 6 through 9 onpage 5 tocomplete the installation of
natural gasmainspuds intheir c orrect locations. _ ,,RT _ 2_,,-,9_-.0
Save theorifices r emoved from theappliance forfuture use.They will //
be needed if this appliance i sagain converted forusewithLPgas.
B. Invertcapin appliance prassum regulator. FIGURE 14
(See figures 10and11 .)
Withtheappliance i nstalled t heappliance regulator should b elocated 5 BURNER MODEL
(36"WIDE)
as shownin eitherfigure3 or figure4 (page 3). Identify thetypeof
appliance regulator and follow the instructions in the appropriate
illustration.
C. Adjust lowflameasinstructed o n page 6 itemC. k
After Steps A,BandChave beencompleted, check theappearance of
eachburner's flameat theHi andLo settings against f igure13.If the
flamesappeartoo largeor too small, makesure all stepswere
completed c orrectly.
_RT t_21W-993-_ (_
FIGURE 15