Craftsman 247.883960 Operator's Manual page 10

7. Push the chute control rod toward the control panel until the hole
in the rod lines up with the middle hole in the chute control input
and insert the cotter pin. See Figure 8.
NOTE: There is a reference hole provided at rear end of control rod to
help know when holes are vertical.
NOTE: The hole furthest from the chute control head is used to
achieve further engagement of the chute control rod into the input shaft
if required. Refer to the Maintenance & Adjustments section for Chute
Control Rod adjustment.
The hole closest to the chute control head is used for manual
movement of the chute assembly if required. Refer to the Controls &
Features section.
8. Check that the cables are properly routed through the cable guide
on top of the engine. See Figure 9.
NOTE: For smoothest operation, the cables should all be to the left of
the hex rod.
9. The extension cord for the electric starter is fastened with a cable
tie to the rear of the auger housing for shipping purposes. Cut the
cable tie and remove cord before operating the unit.
SET-UP
Shear Pins
Holes are located in the handle panel for convenient shear pin storage.
See Figure 10. Refer to the Operation section for more information
regarding shear pin replacement.
ASSEMBLY
Figure 8
10
Figure 9
Figure 10