Programming Instructions; Programming Multiple Stages; Programming Pause During Stage(S) - Amana RC519M Service Manual

Programming Instructions

Programming Multiple Stages

1. Open oven door. Display shows "door".
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press pad 1 for five seconds. After five seconds,
signal sounds. Display shows "P" and active menu.
3. Press ADD pad.
4. Press desired menu pad. Display shows active
menu.
5. Press desired number pad. Display shows selected
number pad, "ITEM", heating time, "COOK LEVEL"
and power level (if other than 100 percent power) for
stage one.
• If multiple stages exist, display shows "STG" and
number of programmed stages.
6. Press number pads to enter desired cooking time.
7. Press POWER LEVEL pad if power level requires
change. Display shows "COOK LEVEL" and current
power level (if other than 100 percent power).
8. Press number pad to enter desired power level.
Display shows new power level if other than 100
percent power. For example, pad 2 is 20 percent
power.
9. Press STATUS pad to advance to next stage. Display
shows "P(1-4)" for one second followed by time and
power level (if other than 100 percent power) for
selected stage.
• "P" represents program and is followed by current
stage.
10.Repeat steps 6–9 for additional stages.
11. Press START pad to enter new heating time and
power level in oven memory. Display shows "P".
12.Press RESET pad or close oven door to exit
programming mode.
Summary of Programming Multiple Stages
1. Open oven door.
2. Press pad 1 for five seconds.
3. Press ADD pad.
4. Press desired menu pad.
5. Press desired number pad.
6. Enter desired cooking time and power level if power
level other than 100% is desired.
7. Press STATUS pad.
8. Enter desired cooking time and power level.
9. Repeat steps 6–9 for additional stages.
10.Press START pad.
11. Press RESET pad or close oven door.
RS5320014 Rev. 0

Programming Pause during Stage(s)

Pause cooking during each or any stage to manipulate
food. Pause occurs halfway through stage.
1. Open oven door. Display shows "door".
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press pad 1 for five seconds. After five seconds,
signal sounds. Display shows "P" and active menu.
3. Press ADD pad.
4. Press desired menu pad. Display shows active
menu.
5. Press desired number pad. Display shows selected
number pad, "ITEM", heating time, "COOK LEVEL"
and power level (if other than 100 percent power) for
stage one.
• If multiple stages exist, display shows "STG" and
number of programmed stages.
6. Press number pads to enter desired cooking time.
7. Press POWER LEVEL pad if power level requires
change. Display shows "COOK LEVEL" and current
power level if other than 100 percent power.
8. Press number pad to enter desired power level.
Display shows new power level if other than 100
percent power. For example, pad 2 is 20 percent
power.
9. Press PAUSE pad.
• Press STATUS pad and repeat steps 5–9 for
additional stages.
10.Press START pad to enter new heating time and
power level in oven memory. Display shows "P".
11. Press RESET pad or close oven door to exit
programming mode.
Summary of Programming Multiple Stages
1. Open oven door.
2. Press pad 1 for five seconds.
3. Press ADD pad.
4. Press desired menu pad.
5. Press desired number pad.
6. Enter desired cooking time and power level.
7. Press PAUSE pad.
8. Press START pad.
9. Press RESET pad or close oven door.
14