Power Wheels Jeep Junior 74240 Owner's Manual And Assembly Instructions page 7

4
Rear Axle
Support
Hole
Screw
Peg
Bottom View
• Position the vehicle body upside down.
• With the cupped side of the rear axle support facing up,
fit the holes in the rear axle support onto the screw pegs
on the vehicle body.
5
Metal
Washer
Plate
Screw
Peg
Rear
Axle
Support
Bottom View
• Fit the two metal washer plates onto the vehicle body
screw pegs extending through the rear axle support.
7
• Insert a #8 x / " trusshead screw through each metal
8
washer plate and into the vehicle body.
• Tighten the screws with a Phillips screwdriver but do not
over-tighten. It is important that the metal washer
plates move freely under the screws.
Assembly
6
Hole
Washer
Screw
Peg
Screw
Peg
Rear Axle
Support
• Insert #8 x
holes in the steering linkage.
• Fit a round washer on the end of each screw.
• Insert one of the screws (with washer) into the screw
peg on the rear axle support. Insert the other screw
(with washer) into the hole in the motor assembly.
• Tighten the screws with a Phillips screwdriver but do
not over-tighten. It is important that the screws not
restrict movement of the steering linkage.
Metal
Washer
Plate
Screw
Peg
7
Bottom View
5
/ " trusshead shoulder screws through the
8
Motor
Assembly
Washer
Steering
Linkage