Starting And Stopping; Assembly Instructions - Flymo Hover Vac User Manual

3
A
1
B
C
D
E
Lock-off button

Assembly Instructions

Assembly of lower handle to hood (A)
1. Place the ends of the lower handle into the slots
2. Secure lower handle to hood by firmly pushing fix-
2
3. Repeat on the other side.
•
Assembly of handle tube to joint (B)
1. Ensure that the joint is centralised on the lower
2. Line up the hole in the joint with the hole in the
3. Insert the square headed bolt through the hole in
4. Insert an M6 nut into the lower wing knob.
5. Fit washer, then wing knob and tighten.
6. Insert handle tube into joint, lining up the holes.
7. Insert screw through joint and handle tube. Fit M5
Assembly of switch handle to handle tube (C)
1. Insert the handle tube into the switch handle,
2. Push bolt through the holes.
3. Insert M6 nut into the upper wing knob.
4. Fit washer, then wing knob and tighten.
Cable clips (D)
1. Fit the cable to the handles with the clips provided.
2. Ensure the the cable is secured under the clip on

Starting and Stopping

Starting
1. Hold as illustrated in Figure E.
2. To start, press the lock-off button down, whilst
Switch lever
Stopping
1. To stop your product, release the switch lever.
ensuring that the joint is facing the correct way
(A1).
ing pin through holes in hood and handle (A2).
NOTE
Should a problem occur when securing handle
with the fixing pin, carefully lever the pin out of
location and repeat steps 1 to 3 above.
handle.
lower handle.
the joint and the hole in the lower handle.
nut and tighten screw.
ensuring the handle is in an upright position and
lining up the holes.
the hood.
pressing the lock-off button, squeeze the switch
lever.