Carton Contents - Flymo Hover Vac User Manual

1
IMPORTANT !
Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
IF ANY PARTS ARE MISSING CONTACT:-
Electrolux Outdoor Products Customer Service Department direct
Telephone : 01325 300303, Fax : 01325 318193
If not used properly this product can be dangerous! This product can cause serious injury to the oper-
ator and others, the warnings and safety instructions must be followed to ensure reasonable safety and
efficiency in using this product. The operator is responsible for following the warning and safety
instructions in this manual and on the product. Never use the product unless the grassbox or guards
provided by the manufacturer are in the correct position.
Explanation of Symbols on the Hover Vac/Mow n Vac
Warning
Read the user instructions carefully to
make sure you understand all the con-
trols and what they do.
Switch off! Remove plug from mains
before adjusting, cleaning or if cable is
entangled or damaged. Keep the cable
away from the cutting parts.
General
1. Never allow children or people unfamiliar with these
instructions to use the product. Local regulations
may restrict the age of the operator.
2. Only use the product in the manner and for the
functions described in these instructions.
3. Never operate the product when you are tired, ill or
under the influence of alcohol, drugs or medicine.
4. The operator or user is responsible for accidents or
hazards occurring to other people or their property.

Carton Contents

cable clip
joint
screw
square headed bolt
cable clip
lower handle
fixing pin
bolt
washer
handle tube
M5 nut
lower wing knob
M6 nut
washer
instruction
manual
Safety
Keep bystanders away. Do not operate
whilst people especially children or pets
are in the area.
Do not operate in the rain or leave the
product outdoors while it is raining.
The use of eye protection is recommend-
ed to protect against objects thrown by
the cutting parts.
Electrical
1. The British Standards Institute recommend the use
of a Residual Current Device (R.C.D.) with a trip-
ping current of not more than 30mA. Even with a
R.C.D. installed 100% safety cannot be guaranteed
and safe working practice must be followed at all
times. Check your R.C.D. every time you use it.
2. Before use, examine cable for damage, replace it if
there are signs of damage or ageing.
3. Do not use the product if the electric cables are
damaged or worn.
switch handle
upper wing knob
M6 nut
electric cable
with moulded
on plug
plastic
cutters