Table of Contents
Advertisement
6. User simulation
[Specifications which does not conform to International
EnergyStar]
A) Preheat mode (The machine enters this mode after passing a
certain time from completion of the final operation.)
•
The fusing section temperature is lower than the normal ready
state.
•
The fan speed is reduced. (Patent avoidance)
•
The energy-saving lamp is turned on and the other display lamps
are also turned on. (Including the ready lamp.)
•
Preheat is terminated when any operation is made (key input,
cassette loading, original setting, or other operation which the
machine can detect). The energy-saving lamp blinks. At the same
time, the fusing section temperature rises to the copy ready level
within 10 sec.
Machine state
A. Warmup
Operation panel
ON
F
Energy-saving LED
Blink
Ready lamp
ON
F
Power switch
ON
@1: When the copy button is pressed during preheating, the machine enters the state of "G. Reserved."
Auto start function
Even during warming up or during resetting after completion of ener-
gy-saving mode, copy condition can be set and copy reservation can
be accepted.
When reservation is made, copying is started when the fusing
temperature of the machine reaches the specified level.
When copy reservation is made, the copy conditions cannot be
changed until the reservation is canceled with the clear key.
B. Ready
C. Copying
ON
ON
F
F
OFF
OFF
D
D
ON
OFF
F
D
ON
ON
8 – 12
B) Auto power shut off mode (The energy-saving effect is greater
than the preheat mode. The machine enters this mode after pass-
ing a certain time from completion of copying. When, however, the
machine is temporarily stopped by paper jam, paper empty, toner
empty (with the toner supply lamp ON), etc., the machine does not
enter this mode.)
•
Power supply is stopped only to the fusing section.
•
The fan speed is reduced. (Patent avoidance)
•
The energy-saving lamp is turned on, and the other lamps are
turned off.
•
When the print button is pressed, the auto power shut off is ter-
minated and the energy-saving lamp blinks. At the same time, the
fusing section temperature rises to the copy ready level within 10
sec.
•
The time from completion of the auto off mode to turning off of the
energy-saving lamp after returning to the ready state is the same
as the max. warm-up time after turning on the power.
@
Time required to enter the preheat mode or auto off mode and
cancellation of the mode can be set by the user program. (For
details, refer to the descriptions on the user program.)
Energy-saving mode
D. Preheating
E.Auto power
(@1)
shut off mode
ON
OFF
F
D
ON
ON
F
F
ON
OFF
F
D
ON
ON
Auto start from D, E
G. Reversed
F. Resetting
(Reset)
ON
ON
F
F
Blink
Blink
ON
OFF
F
D
ON
ON
Advertisement
Chapters
Table of Contents
