Sharp SF-1014 Service Manual page 101

4. Set value recording sheet
Purpose/kind Section
Adjustment Paper feed section
Optical unit
SPF unit
Developing unit
Setting Specifications
Fuser unit
Process
Maintenance counter
Memorizef•%!alues in theolumn ofxSet valu for ef cient s vicing hen the memory trouble occurs and the EEPROm is replaced.
Make a copy of this sheet and use with the service sheet.
Main code Sub code Set value
51 2
26 8
45
46 1
47
48 1
2
50 1
48 3
51 2
25 2
26 6
26 13
43 1
2
44 1
21 1
10 – 4
Contents
Description
Adjustment value of contact pressure of the paper on the main
body resist roller
Adjustment value (lens shift amount adjustment value) of copy
magnification ratio in zoom copying
Adjustment value of copy paper lead edge void amount
Adjustment value of copy density (exposure level) in each copy
mode and of copy density gradient (exposure gradient)
Manual copy mode density level 1 (Not toner save mode)
Manual copy mode density level 5 (Not toner save mode)
Manual copy mode density level 1 (Toner save mode)
Manual copy mode density level 5 (Toner save mode)
Auto copy mode density level 1 (Not toner save mode)
Auto copy mode density level 5 (Not toner save mode)
Auto copy mode density level 1 (Toner save mode)
Auto copy mode density level 5 (Toner save mode)
Photo copy mode density level 1 (Not toner save mode)
Photo copy mode density level 5 (Not toner save mode)
The AE sensor and the optical section characteristics memory
data for the change in the copy lamp application voltage
The vertical copy magnification ratio adjustment value
The horizontal copy magnification ratio adjustment value (when
the document table is used)
The adjustment value of copy image position on the copy
paper
SEt value A
Set value B
Set value C
The horizontal copy magnification ratio adjustment value
(When the SPF is used)
The adjustment value of the contact pressure between the SPF
resist roller and the document
Setting the toner concentration level
Destination specifications
Setting of the main motor operation mode in warming up
The set value of fusing temperature
Fusing temperature setting in the power save mode
Image correction mode function setting
Setting of the maintenance cycle