Connection To Audio Equipments Etc; Digital Audio Output Terminal; Line 1/Line Out Jacks; Power Cord Receptacle - Onkyo DR-635 Instruction Manual

Connection to Audio Equipments etc.

Caution:
Switch off the power to all equipment before
making connections.
Read the instructions of each component you
intend to use with this unit.
Be sure to insert each plug securely. To prevent
hum and noise, avoid bundling the signal
interconnection cables together with the AC power
cord or speaker cables.
D

Digital audio output terminal

Digital audio from DVD-Video, CD and video CD is out-
put from this terminal. Connect an amplifiers including
a decoder, or digital audio devices such as CD
recorders, etc. to this jack using commercially-available
coaxial digital audio cable.
Select "ALL" or "PCM only" in the DIGITAL AUDIO
SETUP.
E

LINE 1/LINE OUT jacks

Analog 2-channel audio signal is input or output from
these jacks. Connect a cassette tape deck etc. to these
jacks using commercially-available RCA cables.
Make sure to connect:
white plug: white jack (L: left channel)
red plug: red jack (R: right channel)
F

Power cord receptacle

After all other connections have been made, insert the
supplied AC power cord into this receptacle, then con-
nect the other end of the power cord into the wall socket.
In order to avoid the risk of electric shock, fire, and
so on, only use the supplied power cord.
If you are not going to use the unit for some time,
disconnect the power cord from the wall socket.

Remote Control

The provided Remote Control allows the unit to be op-
erated from a distance.
When operating the Remote Control, point it towards
the remote sensor on the front panel of the unit.
Even if the Remote Control is operated within
the effective range (5m), remote control operation
may be impossible if there are any obstacles
between the unit and the remote control.
If the Remote Control is operated near other
products which generate infrared rays, or if other
remote control devices using infrared rays are used
near the unit, it may operate incorrectly. Conversely,
the other products may operate incorrectly.

Battery Installation

1. Remove the battery compartment cover.
2. Insert two "AAA"± (R03 or UM-4) dry batteries. Make
sure that the batteries are inserted with their
positive " "±and negative " "±poles positioned
correctly.
3. Close the cover.

Precautions concerning batteries

Be sure to insert the batteries with correct positive
" " and negative " " polarities.
Use batteries of the same type. Never use different
types of batteries together.
Either rechargeable or non-rechargeable batteries
can be used. Refer to the precautions on their labels.
When the Remote Control is not to be used for a
long time (more than a month), remove the battery
from the Remote Control to prevent it from
leaking.
If the batteries leak, wipe away the leakage inside
the battery compartment and replace the batteries
with new ones.
Do not use any batteries other than those specified.
Do not mix new batteries with old ones.
Do not heat or disassemble batteries. Never throw
them in fire or water.
Do not carry or store batteries with other metallic
objects. Doing so could cause batteries to short
circuit, leak or explode.
Never recharge a battery unless it is confirmed to
be a rechargeable type.
7