Table of Contents
Advertisement
(1) Fix the top of this unit to the control panel at two points by loosely tightening the screws (M4) that were procured locally.
Fix the bottom in place with two screws and then tighten all four of the screws.
(2) To remove the cover, as shown in the figure, remove the two screws for fixing the cover in place and then remove the cover by
unhooking the upper hook section from the lower case. To attach the cover, hook the upper hook section on the lower case and then
fix the cover in place with the two screws that were removed.
Note: Two hooks are located on the upper section of the cover.
Screw pitch
150
(
5
Hooks
Screws for fixing
the cover
5
/
29
)
32
110
(
4
11
/
)
32
Unit: mm (in)
- Quick Links:
- Wiring Method
Hide quick links:
Advertisement
Table of Contents
