Front Panel - JBL SYNTHESIS SDEC-4500 Installer Manual

SDEC3000.4500.om.qxd 4/16/09
D
ETAILED
I /O
NPUT UTPUT
Each channel has three LED indicators showing:
C
LIP
Illuminated – Indicates clipping in the analog domain for each channel of the fitted input or output card.
The LED will light at +18.5dB.
S
IGNAL
Illuminated – The signal LED will light for each channel of a fitted input or output card when the signal
reaches or exceeds the signal threshold of – 20dB.
S /48V
YNC
This feature is currently not supported by JBL Synthesis (lights to indicate that + 48V "phantom" power has
been activated for the relevant channel of a fitted input card or that Digital Sync is valid).
USB P
ORT
This is currently for future use and is not supported (SDEC 4500 does not include USB).
D A
ATA CTIVITY
The data activity LED will flash to indicate that the device is communicating with another control device, either
on the network or via the serial or control ports.
N L
ETWORK
The network link LED indicates the presence of Ethernet cables. If no cables are connected, the LED is unlit.
The network link is used for configuring and calibrating the Synthesis system when using the DACS calibration.
LCD (L
IQUID
The LCD indicates the name/ID and IP address of the unit.
H
OLD
Pressing and holding the Hold switch will cycle the LCD through its contrast range.
L
OCATE
Pressing the Locate switch on the front of the unit will illuminate the Locate switch on the rear.
10:06 AM Page 5
D – F P
IAGRAM RONT
C M
ARD ONITORING
INK
C D )
RYSTAL ISPLAY
ANEL
5