Troubleshooting; Specifications; Psm200 System; P2T Transmixer - Shure PSM200 User Manual

TROUBLESHOOTING

PROBLEM
No sound at the receiver
Low receiver range
Receiver sounds fuzzy or distorted
Low audio output at the receiver

ACCESSORIES

Furnished Accessories

P2T TransMixer

AC Adaptor . . . . . . . . . . . . . . . . . . . . .
Single Mount Rack Bracket
Dual Mount Rack Bracket
Straddle Bars . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Hardware Kit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Optional Equipment
AuxPander:
The Shure AuxPander auxiliary expander extends the capabili-
ties of a standard mixing console by providing eight additional
auxiliary sends. It is designed ideally for use with multiple per-
sonal monitoring systems.

SPECIFICATIONS

PSM200 System

RF Carrier Frequency Range
518–865 MHz (country dependent)
Operating Range
100 m (300 ft.) under optimal conditions
Audio Frequency Response
30 Hz to 12 kHz (+/–3 dB); earphone dependent
Total Harmonic Distortion (1 kHz)
<1% typical (Ref. ±35 kHz deviation)
P2T TransMixer
RF Output Power
30 mW (+15 dBm) typical conducted (country dependent)
Modulation Limiter
Internal peak limiter (>10:1 hard knee compression)
Antenna
1/4 Wavelength, semi-rigid, PCB Mount
SOLUTION
n Check the power cord on the TransMixer and make sure it is
powered on.
n Make sure both the TransMixer and the P2R Receiver are set to
the same frequency channel.
n Make sure the earphones are plugged in to the receiver and the
volume is up.
Make sure the Receiver is on and the battery is good.
n
n Check the incoming audio connections on the TransMixer.
Try to maintain line-of-sight between the TransMixer and Receiver
n
antennas.
n Try another frequency in case interference is limiting the range.
n Check for television channel interference. More information is
available at www.shure.com.
n Make sure no other TransMixers or wireless transmitters are oper-
ating on your frequency.
n Make sure the TransMixer input level is lighting yellow LEDs for
optimum performance.
n Make sure you are using a fresh battery in the P2R.
n Make sure the TransMixer input level is lighting yellow LEDs for
optimum performance.
n Make sure the P2R Receiver's volume knob is up.
PS20, PS20E, PS20UK
. . . . . . . . . . . . . . . . . . . . . 53A8484
. . . . . . . . . . . . . . . . . . . . . . 53B8484
53A8443
90AD8100
ENGLISH
P2R Receiver
1/4-inch mono 20 foot cable
P4M:
The P4M is a highly versatile four–channel, two–bus stereo
mic/line mixer designed to optimize personal (in–ear) monitor
systems in live performance applications.
Modulation
FM ±35 kHz Deviation (Nominal)
Signal-to-Noise Ratio
80 dB typical (A-weighted)
Operating Temperature
–7° C to +49° C
(+20° F to +120° F)
Current
170 mA maximum
Dimensions
220 mm x 140 mm x 40 mm (8.6 in. x 5.6 in. x 1.7 in.)
Net Weight
370 g (13 oz.)
12
. . . . . . . . . . . . . . . . . . . 90B4677