Shure P9HW Manual

General Description

The Shure P9HW is a wired, two-channel stereo bodypack system designed
to replace loudspeakers used for onstage monitoring. The portable, lightweight
P9HW has several advantages over onstage monitor loudspeakers: it is less
visible, offers improved clarity and control of sound, reduces the chances of
P9HW Bodypack
① Audio Input
Use the supplied Y-splitter cable to connect up to two sources.
Important: Align the red dot on the cable with the notch inside the bodypack
input.
Setup
① Insert batteries
Use the Shure SB900 rechargeable battery pack or two AA batteries.
② Connect the bodypack to an audio source using the supplied Y-
splitter cable
Connect the 5-pin LEMO connector to the bodypack, with the red dot on the
cable aligned with the notch inside the bodypack connector. Route the two
XLR connectors on the cable to the appropriate mixer outputs. See the system
overview diagram for a signal routing example.
Note: the bodypack can connect either directly to the mixer or through a patch
bay on stage.
③ Put on the earphones and connect them to the headphone output
The P9HW is designed to perform best with Shure earphones, but works
with any headphones or in-ear monitors that have a standard 1/8-inch (3.5
mm) stereo plug.
④ Turn the power on
Turn the volume knob clockwise until it clicks to turn on the power.
Caution: do not turn the volume knob all the way up when turning the
power on.
©2017 Shure Incorporated
feedback, and reduces stage clutter. It is a versatile system, designed for
use in sound reinforcement applications including public address, live music,
studio recording, broadcast, and theater.
② Clip Indicator
Illuminates when the input is overloaded. Turn the volume down at the mixer
until the light remains off.
③ Volume Knob / Power Switch
Turn to power on/off and adjust headphone volume
④ Battery LED
Indicates battery health
Note: see the battery life table for specific runtime values
⑤ Headphone Output
Use earphones or headphones with a 3.5 mm (1/8-inch) plug
⑥ Display
Shows settings and menu navigation
⑦ Navigation buttons (▲▼)
Use to scroll through menu and adjust settings
⑧ Exit button
Press to return to previous screen
⑨ Enter button
Press to enter a menu screen or to confirm a setting
⑩ Factory Service Window
Used for importing firmware onto the bodypack at the factory (not user-ser-
viceable)
⑪ Battery Compartment
Uses a Shure SB900 rechargeable battery or two AA batteries
⑫ Removable AA Adapter
Remove to use with a Shure SB900 rechargeable battery
Note: To remove, open the door and slide the adapter out. To reinstall, press
the adapter into place—there is an audible click when seated.
⑤ Slowly increase the volume until it reaches a comfortable level for
listening
To set a maximum volume limit, use the VLIMIT function. See the utilities
section of this guide for more information.
Wired Bodypack Personal Monitor
P9HW
1/8