JBL GTS100 Owner's Manual page 11

LINE
L
R
Line Level RCA Inputs
Line Selector
Gain Control
Input Mode
Speaker Input Connector
Crossover Mode Selector
6. Crossover Mode Selector – This
switch controls the built in crossover.
Set the switch to "Off" for full band
operation. Set this switch to "Low" to
activate the 80Hz low pass filter on the
amplifier (for subwoofer use). Set the
switch to "High" to activate the 100Hz
high pass filter for use with satellite
speakers. Note that the filter does not
affect the line level outputs on the
amplifier.
7. Fuse – 20 Amp ATC type Fuse.
8., 9., 10. Power Connector –
Connection for included power wire har-
ness. See "Power Supply Connections"
INPUT MODE SPEAKER
L + R
IN OUT R INPUTS
NOM
+
R
STEREO
-
MIN MAX
GAIN
POWER
Power Indicator
CROSSOVER SPEAKER
OFF HIGH OUTPUTS
+
+ +
L
R L
LOW
BAT(+) REM GND
-
- -
BRIDGED
on page 14 and the wiring diagram on
page 13 for information on wire color
codes and proper connections.
11. Speaker Output Connector –
Connection for included speaker output
harness. See "Speaker Connections"
section on page 17 for information on
wire color codes.
12. Power Indicator LED – Power indi-
cator light glows for normal operation
when the amplifier is activated by either
the remote or common sense turn-on
circuits.
FUSE 20A
20A
POWER
Fuse
Battery Ground
Remote Turn-On
Battery (+) In
Speaker Output Connector
Power
Connector
11