Specifications - JBL INVADER Manual

Selfpowered multimedia speakers and subwoofer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Too much bass or treble.
Subwoofer emits a loud
hum or buzzing noise.
Speaker system
experiences radio
frequency interference or
picks up a radio station

SPECIFICATIONS

Manufacturer
Model
Drivers (satellite)
Drivers (subwoofer)
Power (satellite)
Power (subwoofer)
Crossover Frequency (subwoofer)
Dimensions
Width:
Satellite
Subwoofer
Depth:
Satellite
Subwoofer
Height:
Satellite
Subwoofer
Input Impedance
Signal-to-Noise ratio
Frequency Response
Input Sensitivity
USA/Canada Power
Maximum Power Consumption
UL/CUL/CE Approved
Regulatory
FCC Statement and Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
a)
Re-orient or relocate the receiving antenna.
b)
Increase the separation between the equipment and receiver.
c)
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
d)
Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT
UNDER FCC RULES.
Document Number: 950-0042
Revision: 06
Check the speaker control
settings.
Bass/Treble level is set too
high
Input cables not plugged in
properly
Input cable may be picking
up interference
Set each of the two knobs
(treble, bass level) on front
of the subwoofer back the
their center /nominal
positions.
Turn Bass/Treble down or
return their settings to the
center position.
Check input cable
connection
Wrap up excess input
cable in order to make as
short as possible
Purchase a ferrite clamp
and attach over input
cable. A clamp can be
purchased at your local
electronics store
Harman Multimedia
JBL INVADER
Phoenix SE
One 6 inch Magnum woofer
12 watts per satellite at 1% THD
32 watts at 1% THD
150 Hz
3.0 inches 75mm
7.5 inches 190mm
4.0 inches 100mm
9.0 inches 225mm
9.5 inches 240mm
12 inches
300mm
>5k Ohm
>85dB
40 – 20 kHz
400 mV rms for rated power output
120 volts, 60Hz AC
120 watts
Description: MANUAL, JBL 4.1, All languages

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents