Toshiba e-Studio 452 Operator's Manual page 113

The stapling position lamp corresponding to the selected stapling position lights in green.
3
Place paper in the lower tray of the finisher.
Jog the paper well and place it with its face down.
Place the paper in front to have it stapled in the front, and in the other end to have it stapled in the
other end.
Check that the manual-stapling lamp lights in green. If not, place the paper again.
4
Release the paper and press the [Manual-stapling] button.
The stapling position lamp blinks when the stapling is completed. Remove the paper.
Be sure to release the paper before the manual stapling.
• Operation can be continued while the manual-stapling lamp lights. If no operation is performed for approx. 15
min., the manual stapling operation is stopped.
• If you want to stop the manual stapling operation during setting, remove paper and press the [Manual-stapling]
button. The shutter in the paper exit area is closed and the operation of the manual stapling is finished.
Specification
Acceptable paper size
Maximum number of sheets
for stapling
Stapling position
LD, LG, LT, LT-R, COMP, 13 LG, 8.5" SQ, 8K, 16K, A3, A4, A4-R, B4,
FOLIO
50 sheets (LT, 8.5" SQ, 16K, A4: 17 - 20 lb. Bond)
30 sheets (LD, LG, LT-R, COMP, 13 LG, 8K, A3, A4-R, B4, FOLIO: 17 - 20
lb. Bond)
30 sheets (LT, 8.5" SQ, 16K, A4: 21 - 28 lb. Bond)
15 sheets (LD, LG, LT-R, COMP, 13 LG, 8K, A3, A4-R, B4, FOLIO: 21 - 28
lb. Bond)
Front, Rear
3
111