Panasonic AJ-HD3700H Operating Instructions Manual page 75

TC/CHR menu
Table of user bit settings
F1 (SOURCE) F2 (TC SLAVE)
INT (internal) TC ——
S LTC ——
S VITC
EXT LTC SLAVE
EXT LTC
DIRECT
°The user bit can be set in all modes except for recording.
DIRECT: The external LTC input signal is recorded directly and output.
It is not synchronized with the internal reference signal.
REGEN: The user bit is slave-locked to the value read out on the tape.
The user bit cannot be set.
EXT REGEN: The user bit is slave-locked to the externally input VITC or LTC.
The user bit cannot be set.
PRESET: The user bit is not locked to the value read out on the tape or external input.
The user bit can be set.
INT UB: In this mode, the previous user bit is retained, and neither the REGEN nor PRESET functions
can be implemented.
To set the user bit again, use the F1 (SOURCE), F2 (TC SLAVE) or F3 (UB SLAVE) key to
select one of the three modes above.
F3 (UB SLAVE) F10 (TCR)
LTC
ON AUTO
VITC
LTC
OFF AUTO
VITC
LTC
ON AUTO
VITC
LTC
OFF AUTO
VITC
LTC
ON AUTO
VITC
LTC
OFF AUDIO
VITC
– 75 –
LUBG mode VUBG mode
INT UB
REGEN
REGEN
INT UB
INT UB
PRESET
PRESET
INT UB
INT UB
EXT REGEN
EXT REGEN
INT UB
INT UB
PRESET
PRESET
INT UB
INT UB
EXT REGEN
DIRECT
INT UB
PRESET°