Advertisement
PN OWNER'S GUIDE
TABLE OF CONTENTS
3 Important Safety Precautions
4 Unpacking the System
®
12 Specifications
Declaration of Conformity
We,
Harman Consumer International
2, route de Tours
72500 Chateau-du-Loir
France
declare in own responsibility that the product described
in this owner's manual is in compliance with technical
standards:
EN 50081-1:1992
EN 50082-1:1997
Robin Marshall
Harman Consumer International
Chateau-du-Loir, France 10/03
2
READ FIRST!
Important Safety Precautions!
13. Unplug this apparatus during light-
ning storms or when unused for long
periods of time.
14. Refer all servicing to qualified
service personnel. Servicing is
required when the apparatus has
been damaged in any way, such as
power-supply cord or plug is dam-
aged, liquid has been spilled or
objects have fallen into the appara-
tus, the apparatus has been exposed
to rain or moisture, does not operate
normally, or has been dropped.
15. Do not use attachments not
recommended by the product
manufacturer, as they may cause
hazards.
16. This product should be operated
only from the type of power source
indicated on the marking label. If you
are not sure of the type of power
1. Read these instructions.
supply to your home, consult your
2. Keep these instructions.
product dealer or local power
3. Heed all warnings.
company. For products intended
to operate from battery power, or
4. Follow all instructions.
other sources, refer to the operating
5. Do not use this apparatus near
instructions.
water.
1 7 . If an outside antenna or cable
6. Clean only with a dry cloth.
system is connected to the product,
7. Do not block any ventilation
be sure the antenna or cable system
openings. Install in accordance with
is grounded so as to provide some
the manufacturer's instructions.
protection against voltage surges
8. Do not install near any heat
and built-up static charges. Article
sources such as radiators, heat
810 of the National Electrical Code,
registers, stoves or other apparatus
ANSI/NFPA 70, provides information
(including amplifiers) that produce
with regard to proper grounding of
heat.
the mast and supporting structure,
9. Do not defeat the safety purpose of
grounding of the lead-in wire to
the polarized or grounding-type plug.
an antenna discharge unit, size of
A polarized plug has two blades with
grounding conductors, location of
one wider than the other. A ground-
antenna-discharge unit, connection
ing-type plug has two blades and a
to grounding electrodes, and require-
third grounding prong. The wide
ments for the grounding electrode.
blade or the third prong are
See Figure A.
provided for your safety. If the
provided plug does not fit into your
Figure A.
outlet, consult an electrician for
Example of Antenna Grounding as per
replacement of the obsolete outlet.
National Electrical Code ANSI/NFPA 70
10. Protect the power cord from being
walked on or pinched, particularly at
plugs, convenience receptacles and
the point where they exit from the
apparatus.
11. Only use attachments/accessories
specified by the manufacturer.
12. Use only with the cart, stand,
tripod, bracket or table specified by
the manufacturer or sold with the
apparatus. When a cart is
used, use caution when
moving the cart/appara-
tus combination to avoid
injury from tip-over.
18. An outside antenna system should
not be located in the vicinity of over-
head power lines or other electric
light or power circuits, or where it
can fall into such power lines or cir-
cuits. When installing an outside
antenna system, extreme care should
be taken to keep from touching such
power lines or circuits, as contact
with them might be fatal.
19. Do not overload wall outlets,
extension cords, or integral conven-
ience receptacles, as this can result
in a risk of fire or electric shock.
20. Never push objects of any kind
into this product through openings, as
they may touch dangerous voltage
points or short-out parts that could
result in a fire or electric shock.
Never spill liquid of any kind on the
product.
21. Do not attempt to service this
product yourself, as opening or
removing covers may expose you to
dangerous voltage or other hazards.
Refer all servicing to qualified
service personnel.
22. When replacement parts are
required, be sure the service tech-
nician has used replacement parts
specified by the manufacturer or that
have the same characteristics as the
original part. Unauthorized substitu-
tions may result in fire, electric shock
or other hazards.
23. Upon completion of any service or
repairs to this product, ask the serv-
ice technician to perform safety
checks to determine that the product
is in proper operating condition.
24. The product should be mounted
to a wall or ceiling only as recom-
mended by the manufacturer.
3
Advertisement
