Replacing The Post-Motor Filter - Bissell 44M3P SERIES User Manual

M
aintenance and care

Replacing the post-motor filter

1. Turn power OFF
2. Unplug the vacuum from electrical outlet.
3. The post-motor filter assists in the filtration
process to return clean air to the room.
It is located behind the door on the side
of the vacuum. If the filter becomes dirty,
open the door, remove the filter and
replace. The white, pleated filter is not
washable.
checking rotating floor brush and drive belt
you should check your vacuum cleaner' s
rotating floor brush and drive belt
regularly for wear or damage. you should
also clean the brush and brush ends of
strings, hair, and carpet fibers. these can
wrap around the brush and alter its
ability to effectively clean your carpet.
also remove any debris that has
accumulated under the brush cover.
1. Turn power off. Unplug vacuum from
electrical outlet.
2. Place handle in low position and turn
vacuum cleaner over so bottom side is up.
3. Remove the seven screws with a Phillips
head screwdriver. Lift the brush cover off.
4. Grasp rotating floor brush at both ends and
lift.
5. Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. Clean strings, hair and other debris from
motor pulley and drive belt areas.
7. Check drive belt carefully for wear, cuts or
stressed areas.
8. Check air passageway for obstructions.
Remove debris from this area.
12
www.pawsitivelycleanpet.com
Open
Door
3.
Brush Cover
8.
Air Passageway
Remove
Filter
8 0 0 . 2 3 7 . 7 6 9 1