Set Up; Connecting; Setting Your Blade Depth - SIZZIX Eclips User Manual

SET UP


SET up

CONNECTING

1. Plug Power Cord into Universal Power Supply .
2. Plug Universal Power Supply into back of eclips Machine .
3. Plug USB cable into back of eclips Machine .
4. Plug flat end of the USB cable into Handheld Remote Control .

SETTING yOUR BLADE DEPTH

NOTICE
DO NOT adjust blade depth while Machine is operating.
Depth Selection
Arrow
Back of machine
2
1
Printed on a ring around the Blade Holder top are Blade Depth Settings . Ranging from 1 to
6, these numbers can be selected individually by turning the wheel to the number relative
to the material you are using .
As a general rule, thinner materials such as paper and vinyl require a lower number
Blade Depth Setting, while thicker materials such as light chipboard and heavy cardstock
require a higher number Blade Depth Setting . For optimal results, try a test cut and make
necessary adjustments to the Blade Depth Setting before performing the final cut .
Lower number = Thinner material
Higher number = Thicker material
3
4
Back of
Handheld Remote Control