•
Low or no remote turn-on voltage. Check remote connections at marine amplifier and
source unit.
•
Blown marine amplifier fuse. Replace with new fast-blow fuse (same rating).
•
Power wires not connected. Check battery and ground wiring at marine amplifier; also
check battery connections.
•
Speaker leads shorted. Check speaker continuity to ground, it should not show a
common ground.
•
Speakers not connected or are blown. Check speaker connections at marine amplifier,
measure coil impedance.
•
Thermal protection circuits are shutting marine amplifier off. Check location for adequate
ventilation; consult an authorized Audiopipe Dealer.
•
Gain is not set properly, or damaged speaker cones. Review Setting Gain; inspect
each speaker cone for signs of damage. (i.e. frozen cone, burning smell, etc.)
•
Incorrect wiring or short circuit. Review Installation and check all wiring connections.
•
Marine amplifier is picking up alternator noise or radiated noise. Turn down input gain;
move audio cables away from power wires. Check power and ground connections on
marine amplifier; install an in-line noise filter on source unit's power wire; check
alternator and/or voltage regulator; test for weak battery or add water to battery.
Frequency Response ..........................................................
Signal Noise Ratio ..............................................................
THD ....................................................................................
Input Sensitivity Low Level .................................................
Input Sensitivity Speaker Level ..........................................
Maximum Power Output .....................................................
Continuous Power Output ...................................................
2 Ohm Stereo Output .........................................................
Bridged Power ....................................................................
Dimensions .........................................................................
Current Consumption @ Max Power Output ......................
20Hz ~ 20kHz
>95dB
.05% all channels driven
250mV ~ 2.5V
500mV ~ 5V
600W (150W x 4)
300W (75W x 4) @ .05% THD
115W x 4 @ .5% THD
230W x 2 @ .5% THD
(H)55 x (W)176 x (L)384 mm
46A @ 600 Watts
- 12 -
English