Related Manuals for Audiopipe APCL-6002
Summary of Contents for Audiopipe APCL-6002
- Page 2 The front panel of the APCL-6002 contains both connections for RCA and speaker level inputs, along with the audio controls as shown below. 5. Gain 1. Filter 6. Output 2. Bass Boost 7. Input 3. X-Over freq 8. Bass Level 4.
- Page 3 The rear panel of the APCL-6002 contains power and speaker connections as shown below. 1. Left Speaker Output 4. Remote Turn-On Input 2. Right Speaker Output 5. Ground Input 3. Battery +12V Input The rear panel of the APCL-6004 contains power and speaker connections as shown below.
- Page 4 Connections for power and speakers APCL-6002...
- Page 5 Connections for power and speakers APCL-6004...
- Page 6 We recommend to have the installation done by an Authorized Audiopipe Dealer. Required power, ground wire and proper external fuse as below: Model Fuse Wire APCL-6002 90 AMP 2 Gauge APCL-6004 150 AMP 0 ~ 2 Gauge We recommend a fuse should be installed away 0.2m from the battery. The ground wire should be connected directly with the chassis of your vehicle which should be metal to metal ground point connection.
- Page 7 The Audiopipe APCL-6002 2-channel amplifier can be used in a variety of system applications. Here are some examples to help plan your own installation. APCL-6002 Bridged - Mono Subwoofer System In this application the amplifier is bridged for mono operation to drive a subwoofer.
- Page 8 2-Channel Full-Range, Satellite, or Subwoofer Stereo System (Set INPUT SELECT Switch to STEREO) APCL-6002 In this application, the amplifier is used in stereo and drives two full-range (or satellite or subwoofer) speakers. NOTE: A passive crossover must be used with satellite speakers.
- Page 9 The Audiopipe APCL-6004 4-channel amplifier can be used in a variety of system applications. Here are some examples to help plan your own installation. APCL-6004 2-Channel Stereo System with Low-Pass Bridged Mono Channel In this application the amplifier is bridged for mono operation to drive a subwoofer.
- Page 10 4-Channel, Satellite, or Subwoofer Stereo System APCL-6004 In this application, the amplifier is used in stereo and drives two full-range (or satellite or subwoofer) speakers. NOTE: A passive crossover must be used with satellite speakers.
- Page 11 Check speaker cables and connections. Problem The amplifier switches on and off. Solution • Check chassis ground connection with amplifier cable terminals and check battery terminals connections and check remote turn-on voltage. For additional questions please contact your authorized Audiopipe dealer.
- Page 12 APCL-6002 Maximum Power Output ..........2000W Continuous Power Output ..........Stereo 2 Ch-300W x 2@ 4 Ohm Stereo 2 Ch-600W x 2@ 2 Ohm Bridge 1 Ch-1200W x 1@ 4 Ohm Frequency Response ............ 20Hz ~ 20kHz Signal to Noise Ration ...........
Need help?
Do you have a question about the APCL-6002 and is the answer not in the manual?
Questions and answers