Table of Contents
Advertisement
Control through the oscilloscope's interface can be found in the screen menu of the channel
to which the amplifier is connected.
Touching the tab indicating the attached amplifier (in this case DA18000AC) will activate the
amplifier menu screen. Figure 4-5.
The amplifier information frame shows the characteristics of the amplifier only.
In some applications it may be desirable to turn the amplifier's AutoColor ID OFF or ON with
touching the Led On frame.
CONNECTING THE AMPLIFIER TO THE TEST CIRCUIT
For all modules and interconnect leads, positive voltages applied to the + input relative to
the – input will deflect the oscilloscope trace towards the top of the screen.
Type K Input Leads
The Type K Interconnect System has been designed to connect directly to female type K
connectors as well as to the higher performance 3.5 mm and 2.92 mm female connectors.
The Interconnect Lead connect to the amplifier and the matched pair of SMA Leads connect
to the Interconnect Lead.
The connector should be tightnened to a torque of 0.06 Nm (8 in.-oz.).
The Type K Input Leads are supplied as a matched pair. Individual cables should
not be interchanged between amplifiers.
DA18000AC-OM-E Rev A
Figure 4-2. Probe menu.
Note
Operation
4-3
Advertisement
Table of Contents
