Autocolor Id; Operation With The Sda 18000 - LeCroy DA18000AC Instruction Manual

DA18000AC Differential Amplifier
To attach the amplifier to the LeCroy oscilloscope, align the interface connector with the
input connector and push the interface toward the oscilloscope.
A click will be heard when the amplifier's interface latches to the oscilloscope. This amplifier
also uses the thumb screws to secure the interface to the oscilloscope.
Thumb screws should be tightened finger tight only. Use of pliers or
another tool may overtighten the screws, resulting in damage to the
oscilloscope.
CAUTION
To remove the DA18000AC from the LeCroy oscilloscope, move the amplifier up and down
while pulling gently till a loud snap is heard indicating that the amplifier is unlatched from the
oscilloscope.

AUTOCOLOR ID

When the amplifier is connected to a SDA 18000, the LED will illuminate in the default color
of the channel to which the amplifier is connected.

OPERATION WITH THE SDA 18000

When the amplifier's output connector is attached to the SDA 18000 oscilloscope's input
connector, the oscilloscope will recognize the amplifier and activate the vertical channel
functions in the user interface. Figure 4-4. Refer to your oscilloscope's instruction manual for
operations of the oscilloscope.
4-2
Figure 4-1. Vertical Menu
DA18000AC-OM-E Rev A